DIY Iron On Patch (DTF) - Cat Breaking Through

The design can be ordered with A4 or A5

• Temperature: Set your iron to Medium-High (around 150' to 160' or cotton/linen setting), ensuring you turn off any steam settings or empty the water reservoir.
  
  
• Fabric Prep: Pre-press your garment for 5 to 10 seconds to remove all wrinkles and eliminate any trapped moisture from the fabric.
  
  
• Placement: Position your DTF transfer face up onto the garment, ensuring it is straight and centered correctly.
  
  
• Pressure: Cover the transfer with a piece of parchment paper or a clean Teflon sheet, then press down firmly with heavy, even pressure across the entire design.
  
  
• Pressing Time: Move the iron slowly and steadily over the entire design for 15 to 20 seconds, making sure every edge and corner receives adequate heat and pressure.
  
  
• Peeling: Let the transfer cool down completely to a warm or cold touch before carefully peeling away the clear backing film at a low angle.
  
  
• Post-Press (Curing): Place the parchment or Teflon sheet back over the exposed design and press for an additional 5 to 10 seconds to seal the print and increase durability.